The Federal Aviation Administration has proposed a new airworthiness directive for Daher TBM 700 turboprop airplanes that would change how maintenance providers inspect the main landing gear for cracks. The notice of proposed rulemaking, published in the Federal Register on November 17, 2026, would supersede AD 2015-17-10 and apply to an estimated 431 airplanes on the U.S. registry.
The existing directive requires repetitive inspections of the main landing gear forging body and lets operators end those inspections by installing reinforced gear. The FAA said cracks have been reported in main landing gear cylinders in service, a condition that could lead to a gear collapse during a takeoff or landing run. Since the earlier rule took effect, additional serviceable parts have been developed, and dye penetrant is no longer an authorized inspection method.
Under the proposal, technicians would perform a special detailed inspection using eddy current or fluorescent penetrant methods at intervals of no more than 240 landings. If a crack is suspected or found, the gear leg must be removed and the finding confirmed through a fluorescent penetrant inspection. Installing a serviceable forging body on both the left and right main gear would end the repetitive inspections. The action covers serial numbers 1 through 638 and 687 fitted with affected parts, and it follows European Union Aviation Safety Agency AD 2026-0076, dated April 10, 2026.
The FAA estimates each inspection at four work hours, or $340 per airplane at an $85 hourly labor rate, for a fleetwide cost of $146,540 per inspection. Replacing a forging body is estimated at $6,340 per airplane, including $6,000 in parts. The agency is accepting comments under Docket No. FAA-2026-13817 through January 4, 2027.
Source: Federal Register -- https://www.govinfo.gov/content/pkg/FR-2026-11-17/pdf/2026-23372.pdf